Operator Manual
Aspect 100T
L100-3063 REV A
21
ELECTRIC SYSTEM
BATTERY FUNCTION (Motorized tables)
When AC power is applied, the battery will begin charging until the battery reaches full
capacity. When it does, the charging will taper off. If the power goes out, the table will
automatically switch to battery back-up mode.
Note: The battery will not charge if the emergency stop switch is pushed down.
An audible tone is sounded when using an operator control function if the battery
charge is low.
Local procedures may be in place for proper disposal or recycling.
For more information about batteries, such as battery life, production
codes and
disposal go to the Linak web site for disposal information.
Select “Products|User Manuals” and click on “Actuators & Electronics”.
Linak documentation can be found at their web site:
LIFT ACTUATOR
TREND ACTUATOR
CONTROLLER CONNECTIONS
110V 60Hz OR 230V 50Hz
3
2
1
PORT
(CHECK INPUT ON LABEL)
DEVICE
SAFE DC VOLTAGES
AC POWER
FOOT CONTROL
LIFT
ACTUATOR
CONTROL BOX
ACTUATOR
TREND
HAND CONTROL
CONTROL COVER
(CONTROL BOX INSIDE)
OPERATOR CONTROL
A
C
FOOT CONTROL
BAT
CONTROL
(SEE BELOW)
COVER
HAND OR
ANGLE
ELEVATE
OR OPTIONAL
1
F
5
3
2
4
B
A
FUSE
"ON" INDICATOR
EMERGENCY
STOP SWITCH
