Operator Manual
Aspect 100RT
L100-3061 REV A
17
If, over time, an actuator is not returning to its programmed position or an actuator or controller has
been replaced, perform the following steps:
1)
Operate each actuator to the retracted position, holding the button in for about 2 to 5 seconds after
the actuator stops retracting.
2)
Reprogram per the preceding steps.
Error/Reset: If the tabletop is not responding when using the hand or foot control, and there is a
long audible tone, hold the two uppermost buttons in until the tone ceases. The hand control must
be plugged into proper position (see the Electric System diagram). Follow the 2 steps
immediately above this paragraph.
Hand Control
Part Number K000-0195 plus label D100-1962
Disposal of Hand Control
Local procedures may be in place for proper disposal or recycling
of electronic parts. For more information about disposal,
see Linak
documentation at their website:
Select “Products\ User Manuals” and click on “Actuators &
Electronics”.
