Unpacking Instructions
Aspect 100-4T G3 and ISR
G3
D100-2916 Rev A 20-APR-2018
3. Inspect the two Shockwatch
™ shock indicator devices for
indication of severe shock. If the vial in the center of the
indicator has turned red as is shown in the picture to the
right, the crate has experienced high shock forces during
transit. Contact IDI immediately for further instructions if
either of these devices have been activated.
4. Remove the cardboard Tabletop
Protector shown in the picture
to the right.
5. Use a Diagonal Cutting Pliers to
cut the Strapping as shown in
the picture to the right. Use
caution to avoid injury as
tension is released. Remove
any cartons containing table
control devices and accessories.
6.
Using a Ratchet Wrench with a 9/16” hex Socket, remove two 3/8” lag
bolts from the end of the Tilt-Skid as shown in the picture above.
7. Remove the top wooden Cleat and bottom Runner on the Tilt-Skid as
shown below.
8. Use a Phillips #2 screw driver or
drill/driver to remove all deck
screws that are fastening the
two steel retaining brackets as
shown in the picture to the
right.
CLEAT
RUNNER
