Idex Hale Sam, Technical Manual

Page: 94 / 223

74
C. Install two (2) 1/4–20 X 1-1/2-in long machine screws (each with one lock and
one flat washer). NOTE: Do NOT over tighten screws.
D. Connect electrical connector according to tags.
4.7.2 Flowmeter (Optional – Used with SAM Or Navigator Pro 9335 Only)
Reference section 5, System Installation, of Style 9335 Navigator Pro With Pressure, Flow CAFS
And Valve Control Installation, Operating, And Maintenance Instructions (P/N 126914) found on
the flash drive provided with the system or on the Hale website (www.haleproducts.com).
Refer to Table 28 for a list of tools and/or consumables required for this procedure.
Table 28. Flowmeter Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
2-1/4-in Wrench Cable Ties (As Required)
Loctite 243
Flowmeter
<See FSG-PL-01506, Sheet 1 & 2,
AKRON FLOW SENSOR>
Perform the following to replace a damaged flowmeter.
Removal
A.
Open SAM panel(s).
B. Note cable tie locations, cut ONLY ties required to R&R flowmeter.
C. At discharge valve motor controller, tag and disconnect wiring.
D. Using a 2-1/4-in wrench, remove retaining nut. See Figure 47.
Figure 47. Flowmeter R&R