Idex Hale Sam, Technical Manual

Page: 156 / 223

136
Figure 108. Governor Menu Screen (Set Units)
I. Touch Unit of Measure row.
J. Touch wrench and gears button (lower right-hand corner).
Figure 109. Select Units Screen
K. Touch applicable text box (right-hand half of screen).
L. Touch check mark button (lower right side of left-hand half of screen). Governor
Menu screen (Figure 109) is displayed.
M. Touch Save button (lower right-hand corner of screen).
N. Touch Back Arrow button (lower left-hand corner of screen).
4.12.3.3 Enable/Disable Suction Pressure Governor
Prior to setting the Suction Pressure Governor enable pressure (and Hysteresis), enable the Suc-
tion Pressure Governor by performing the following.
A.
On SAM Pump Controller (Figure 28, page 35), display SAM Pump Controller
Menu screen (see paragraph 2.6.1.2, SAM Pump Controller Password Screen Ac-
cess, page 35).
B. Touch Governor Settings button. Governor Menu screen (Figure 108) is dis-
played.
C. On Governor Menu screen, touch Page Down button (lower left-hand side of
screen) until Page 4 is displayed (highlighted) in upper right-hand corner of
screen.