Idex Hale Sam, Operation Installation Maintenance Manual

Page: 37 / 141

21
Additional navigation is available during the transitions. If immediate opening of a master intake
valve is required, touch the PRIMING or VENTING button (popup text). Then acknowledge the
Force INTAKE X Open? confirmation popup that appears by touching the YES button. (NOTE: Us-
ing this feature will override the priming function and could allow air from the supply hose into
the pump.) See Figure 16.
Figure 16. Force INTAKE X Open? Popup
NOTE: The master intake valve continues to transition to the open state, even if the Force IN-
TAKE X Open? popup is displayed. So even if the popup is not acknowledged the valve transitions
in the normal time.
4.2
SAM Touchscreens
The SAM Control Center is a full-color display that integrates SAM and SAM controls and indica-
tors into an easy-to-read and easy to command operator interface. The touchscreen is a 10.6-
inch landscape model and a high-speed processor to boot quickly as well as seamlessly display
graphics and respond to touch commands. The display is easily viewed in full sunlight and is
glove-friendly and rugged.
It is IMPORTANT to note that the SAM touchscreen does NOT support multi-touch, if multiple sim-
ultaneous touches accidently occur, the screen responds as if touched in the middle of the multi-
ple touch points.
SAM supports up to three (3) SAM Control Center displays, however, one (and ONLY one) must
be configured as the master. The SAM Control Centers are typically mounted as follows: Driver
side operators panel, passenger side officer panel, or as an aerial pedestal.