C O N N E C T W I T H C O N F I D E N C E
™
5
Remove carbon seal half from rear bracket with a round object. Tap
gently with a hammer. Take care not to crack seal if reusing. Once
disassembled; clean all reusable parts thoroughly, removing any
traces of old gasket material and trapped / dried liquids from pump.
DISASSEMBLY INSTRUCTIONS:
At this time, it may be necessary to polish the drive unit shaft to
remove any corrosion that may have formed.
7
6
Install the pump slinger (12706) on to the drive unit shaft. The
slinger should be slid all the way back on the shaft of the drive unit
so that the slinger covers the step on the drive unit shaft as shown.
Place the seal O-ring (12710) behind the lip of the carbon seal half.
2
1
ASSEMBLY INSTRUCTIONS:
To install the carbon seal (12713) half into the rear bracket use a
tool such as a 1 ½″ pipe nipple or arbor press to give even pres-
sure on the metal flange of the seal housing during installation.
Gently press the seal into position until it bottoms.
Clean the threads of the bracket screws (12715A) thoroughly. Once
clean, install the four flat washers (12901) and four screw head
O-rings (12717) onto each of the bracket screws.
4
3
