Identiv uTrust 4711F, Reference Manual

Page: 6 / 92

Document Version 1.2 Last revised on
2017-09-26
Page 6 of 92
Reference Manual for uTrust 4701F and uTrust 4711F Readers
1. Legal information
1.1. Disclaimers
The content published in this document is believed to be accurate. However, Identiv does not provide
any representation or warranty regarding the accuracy or completeness of its content, or regarding
the consequences of your use of the information contained herein.
Identiv reserves the right to change the content of this document without prior notice. The content
of this document supersedes the content of any previous versions of the same document. This
document may contain application descriptions and/or source code examples, which are for
illustrative purposes only. Identiv gives no representation or warranty that such descriptions or
examples are suitable for the application that you may want to use them for.
Should you notice any problems with this document, please provide your feedback
to
support@identiv.com .
1.2. FCC Rules
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
Information to user: Changes or modifications not expressly approved by Identiv could void the user's
authority to operate the equipment.”