IDEC WB1F Series, User Manual

Page: 7 / 116

2. Installation & wiring 3. Functions 4. Support tool 5. Appendix 1. Overview
vi
SAFETY PRECAUTATIONS
Caution Caution
z
Do not connect the product to a power supply outside the rated power supply voltage range
or to an AC power supply. Otherwise there is a risk of explosion or burnout.
z
Mistakenly wiring the product may cause the internal circuit to be damaged. Wire the input
and output circuits by referring to the connection examples in
F
P. 2-5 "2. 3. 1 Wiring the
RS-232 type" . This product is not equipped with a protection circuit for a reversed power sup-
ply connection, so there is a risk of damage when the power supply connection is reversed.
Use extreme caution when connecting the power supply.
z
Avoid parallel wiring of the product's wires in the same conduit or duct with high voltage
lines or power lines (inverter power lines in particular) as this may cause malfunction or dam-
age due to the effect of induction noise.
z
If the wires are long and when there is a risk of being affected by power sources or solenoids,
independently wire the product as a general rule.
z
Avoid installing or using the product in the following locations as there is a risk of malfunc-
tion or damage.
- Near induction equipment or heat sources
- Locations with many vibrations or shocks
- Dusty and dirty locations
- In an atmosphere with hazardous gases such as sulfidizing gas
- Locations in direct contact with water, oils, or chemicals
- Outdoors
z
This product is not an explosion-proof product. Confirm that explosion-proof capabilities are
not required when installing the product.
Precautions for Use
Caution Caution
z
Use the product in the environment listed in the catalog and manual. If this product is used
in locations with high temperatures, high humidity, condensation, corrosive gas, or excessive
vibration/shock, there is a risk of electric shock, fire, and malfunction.
z
The usage environment pollution degree for this product is "pollution degree 2". Use the
product in a pollution degree 2 environment. (Based on the IEC 60664-1 standard)
z
The power supply reset time is 300 ms, so perform operations 300 ms after turning the power on.
z
At initial startup, perform operations 10 s after turning the power on.
z
When the load and the unit are connected to different power supplies, always turn on the unit's power
supply first.
z
Install the product so that the reading window is not directly exposed to sunlight or fluorescent light.
z
The non-volatile memory equipped on WB1F can be overwritten 100,000 times.