iDeaPLAY DF1302, User Manual

Page: 13 / 14

-12-
9 Important Safety Precautions
Always follow these basic safety precautions when using our Digital Photo Frame (DPF). This
will reduce the risk of fire, electric shock, and injury.
WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or
moisture. Do not remove the cover. There are no user-serviceable parts inside. Refer all
servicing to qualified personnel.
• The DPF is for indoor use only.
• Unplug the DPF before performing care and maintenance.
• Do not block the ventilation holes on the back of the DPF at any time.
• Keep your DPF out of direct sunlight and heat sources.
• Route the power cable so that it is not likely to be walked on or pinched by items placed
on or against it. Pay particular attention to the point where the cable attaches to the DPF.
• Only use the AC adapter included with the DPF. Using any other power adapter will void
warranty.
• Unplug the power cord from the power outlet when the unit is not in use.
Cleaning the DPF
Treat the screen gently.
To clean fingerprints or dust from the LCD screen we recommend using a soft, non-abrasive
cloth such as a camera lens cloth.
If you use a commercial LCD cleaning kit, do not apply the cleaning fluid directly to the LCD
screen. Clean the LCD screen with the cleaning solution applied to the cleaning cloth.
Clean the outer surface of the DPF with a soft cloth dampened with water.
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter. To comply with FCC RF exposure compliance
requirements, this grant is applicable to only Mobile Configurations. The antennas used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.