14
4
1
2
5
3
Marking-based cutting
• By pressing operating control
5
upwards,
move back gauge to the rear.
• Insert the paper and slide it using the paper
knock-up block
4
to the back gauge
1
and
side stop
2
to the left and right.
•
Press operating control
5
downwards until
the marking on the item to be cut is under the
optical cutting line indicator
3
.
• The further the operating control
5
is
pressed downwards, the quicker the back
gauge
1
moves to the front.
Moving the back gauge to the rear is only
possible in the rapid mode by pressing the
operating control
5
upwards.
Cutting to a specified dimension
• Enter dimension in the numeric keypad.
Dimension appears in red (an incorrectly
entered dimension can be cleared by
tapping
C
).
•
START
- tap on.
Dimension is moved to and again appears in
white after reaching the required position.
• Insert the paper and slide it using the paper
knock-up block
4
to the back gauge
1
and
side stop
2
to the left and right.
• Activate the cut.
RAPID SELECTION cutting
DIN and readily programmable dimensions can
be called up from the respective symbols. DIN
A2, A3, A4, A5, A6, A7, B3 und B4 or 4¼”, 5½”, 7”,
8½”, 11”, 12”, 14” and 17” (
inch
) are saved.
•
+
Tap on to program the next available
RAPID SELECTION. Enter the dimension and
save with
.
• To change RAPID SELECION dimensions,
press the corresponding dimension and keep
pressed, then to
.
• To clear RAPID SELECION dimensions, press
the corresponding dimension and keep
pressed, then to
.
home - mode
Operating / Multi-Touch Display
