123800 Iss 3 -13-
UniPRO Gbis
User Guide
GB
Setup
To set up the tester parameters, first press F4 (SETUP) from the HOME
screen, with the DSL circuit disconnected. This stops all current tests and
displays the main SETUP screen:
Following initialisation, the following information is displayed in the bottom
left corner:
•
DSL System version number
•
Software version number
•
Firmware version number
•
MAC address of the tester
The main SETUP screen provides access to the individual SETUP screens:
•
DSL – Set up the DSL and Bonding parameters
•
SYSTEM – Set up the System parameters, save / load the setup to
USB and update the tester software
•
DEFAULT – Save / load the default setup
•
FACTORY – Restore the factory settings
Press F6 (OK) to confirm the new settings, return to the HOME screen and
restart the tests. Note that if the tester is switched OFF while in SETUP,
none of the new settings are saved.
The following applies to all of the individual SETUP screens:
•
Press F1 (
↑
) to move the highlight to the next parameter above
•
Press F2 (+) to increase the value of the highlighted parameter
•
Press F3 (-) to decrease the value of the highlighted parameter
•
Press F4 (
↓
) to move the highlight to the next parameter below
