Classic
LXRS, RS Propane
-
User's
3
1 BOILER CONTROLS
TO RELIGHT THE BOILER
Repeat the procedure 1 - 10, detailed in 'To light the boiler'.
LOSS OF SYSTEM WATER PRESSURE
Standard boilers fitted with Classic Sealed System Units only
If the red arrow on the module pressure gauge is set above zero
and the system pressure is seen to fall below this value over a
period of time then a water leak is indicated. In this event a CORGI
registered installer should be consulted.
DO NOT OPERATE THE BOILER IF THE PRESSURE HAS
REDUCED TO ZERO FROM THE ORIGINAL SETTING.
ESCAPE OF GAS
Should a gas leak be suspected, contact your local gas supplier
without delay.
Do NOT search for gas leaks with a naked
flame.
CLEANING
For normal cleaning simply dust with a dry cloth. To remove
stubborn marks and stains use a damp cloth and mild detergent.
DO NOT use abrasive cleaning materials.
MAINTENANCE
The appliance should be serviced at least once a year by a
CORGI registered installer.
WARNING
.
If no frost protection is provided and frost is likely
during a short absence from home, leave the heating controls at a
reduced temperature setting.
For longer periods, the entire system should be drained - including
the domestic water supply. If the system includes a frost thermostat
then, during cold weather, the boiler should be turned OFF at the
time switch(es) ONLY. The mains supply should be left switched
ON, with the boiler thermostat left in the normal running position.
BOILER OVERHEAT THERMOSTAT (If fitted)
The boiler is fitted with a safety 'cutout' thermostat. This thermostat
will extinguish the pilot and shut down the boiler in the event of
overheating. Should this occur allow the boiler to cool, press the
reset button (F) then relight as detailed in steps 1-10 in 'To light
the boiler.
Deluxe Model
LEGEND
A
Gas control knob
B
Sightglass
C
Thermostat knob
D
Igniter button
E
Gas inlet cock (shown in the OPEN position)
F
Overheat thermostat reset button (if fitted)
Standard Model
View inside the boiler controls area
If the cutout condition still persists then turn off the boiler and consult
a CORGI registered installer.
CONTROL OF WATER TEMPERATURE
1.
Adjust the boiler thermostat (C) to give the required temperature
for central heating.
2.
The boiler thermostat automatically switches the main burner
OFF and ON to maintain the selected temperature. The pilot
burner remains alight continuously to give re-ignition of the main
burner.
