Spec No: 1S6810, Rev : 0
Page 2 of 2
Anderson Power Products®
13 Pratts Junction Road
Sterling, MA 01564-2305 USA
Tel: 978-422-3600
Fax: 978-422-0128
www.andersonpower.com
ISO 9001 Certified
Step 3:
Thread or push auxiliary cables thru the rear of the SBE/X housing.
Step 4:
Line up the 1x4 housing with open end up as shown in Figure 1
Step 5:
Insert the crimped contacts from the rear of the housing using an insertion tool PM1002G1 in direction as
shown in Figure 1. When properly inserted the contacts will “click” into place. Pull back on the contacts with
a light tug to ensure that contacts are fully seated. When the cable is twisted, the contacts should rotate
freely.
Step 6:
Install the 1x4 auxiliary housing into the SBE in orientation as shown. Install two retaining pins or alternate
retaining clip to secure the auxiliary housing. (Figure 2)
Figure 1
Open Side
Figure 2
