PCSA Circuit board holder
Pag. 4
Using pc board assembly jig in vertical position
ideal-tek s.a.
via A. Monti 10, 6828 Balerna (switzerland) Tel. +41 (0)91 683 32 29 Fax +41 (0)91 683 03 71 [email protected] www.ideal-tek.com
How to use PCSA detachable assembly jigs for pc board
Sliding rails may be positioned by means of self-
locking sleeves. A system of springs makes it
possible to insert and remove printed circuit boards
without changing position of sleeves.
Turn the knob to remove the middle bridge.
Moveable couplings, located on the rear side of the
assembly jigs for attaching the PC assembly jig to the
frame. These couplings keep the PC assembly jig from
detaching from the frame.
Positioning of the lower corners of the
PC Assembly Jig in the toothed guides
located on the frame.
Positioning at 70° angle
Positioning at 80° angle
Positioning at 90° angle
Practical use of PC Assembly Jig with PC Board in place.
Unsoldering of components carried out with PC Assembly Jig in
vertical positions.
PC Assembly jig with component-press lid closed
screwed or clamped to work-top, in relation to the
height of the components.
Foam rubber-lined lid for holding components in
place. May be raised by applying pressure to front
buttons.
Easy to unslot and detach various parts. (Frame-PC
holder unit-component-Press Lid).
PC board assembly jig can be raised by turning lateral
knobs. Self-adjustment to frame at right working
angle, after unit raising.
