www.ideal-tek.com
Switzerland
8
Dino-Lite User manual
ENGLISH
Measurement tools – Many different measurement types can be done with
the measurement tools. The double flash icon gives you access to the grid
and ruler settings.
Notice:
The measurement and calibration feature is only available for
certain models. For the DinoEye models, it is recommended to make
calibrated measurements only.
LINE
Left click and drag to the desired length, and click
again to finish.
CONTINUOUS LINE
Click and drag to form one section of distance,
click again to start another section. Continue until
the total desired distance is measured. Double click
to finish.
POINT TO LINE
Create a line to represent the base by clicking once
to start, drag, and then click again to set the end-
point. Branch off from the base line to start measur-
ing the line that is 90 degrees from the base
line and a final click to finish the measurement.
POLYGON
Click and drag to form the desired length, and click
again to start the next section. When finished, dou-
ble click to finish the polygon measurement.
RADIUS CIRCLE
Click and extend out to the desired radius.
DIAMETER
Click and extend out to the desired dia-meter.
THREE POINT CIRCLE
Click on any three points on the circle you wish to
measure.
THREE POINT ARC
Click on three consecutive points on an arc to mea-
sure.
