30
23
Slide the olives onto the pipes. Screw the
two connectors onto the wall brackets by
hand until they stop against the olives.
Use a 23mm A/F spanner (or adjustable)
on the connectors to tighten.
The connectors will have to be securely
tightened to form the necessary compres-
sion joint between the olive, wall bracket
& connector.
When the sealant has set, slide the
covers onto the inlet legs (captive nuts) of
the mixer. The covers have o-rings fitted
in the bore, ensure the flats on the captive
nut remain exposed to allow them to be
screwed onto the adaptors.
NOTE: The two sealing washers can be
inserted into the captive nut bores, where
they will be retained during installation.
Assemble the shower mixer to the
adaptors remembering to ensure
that the sealing washers/ filters
are inserted between the adaptors
and the shower valve inlets. Keep
the mixer parallel to the wall whilst
screwing the captive nuts clockwise
by hand. Carefully use a 30mm A/F
spanner or strap wrench to tighten
and make a water tight seal.
O-rings can be
wetted with water to
help them slide.
The hose from the shower kit should
be connected to the shower outlet
located on the underside mixer body.
Ensure hose seal is in place.
Ensuring the domed area of the strainer
is pointing outwards (not into the mixer).
Turn on the water supplies, ensure that there are no leaks. The mixer installation is complete
The shower kits are supplied with their own fitting instructions, next step is to position & install the
appropriate shower kit.
8
6
7
14
NOTE FOR IRELAND: 15mm olives are
supplied with this product. Use 1/2”
olives if 1/2” supply pipes are fitted.
The two captive nuts
should rotate freely.
