Completing the Installation
Step #4-Adding Door Seal and Draft•Stopper
™
Your pet door includes two Seal Extrusions which mount into the slots on the side of the V.I.P. Pet Door panel.
To properly measure for installation, close your sliding door against the pet door, measure length from top of
slider to the bottom sill of door frame.
After measuring length,
use a hacksaw to cut door
Seal Extrusions to length
(see Picture #24) and press
into slots. (see Picture #25)
The Draft•Stopper™ attaches to the moving section of your sliding glass door.
To install the Draft•Stopper™, measure the vertical distance, or height of exposed
glass, between top and bottom frames of the sliding door. Cut Draft•Stopper™
to size with scissors using this length.
Starting at top, attach Draft•Stopper™ by aligning edge so that it rubs lightly
against glass. (see Picture #26) Pull paper off tape and gently press in place
while working slowly down the Draft•Stopper™. Do not press firmly in the event
that repositioning is necessary.
NOTE:
Be sure that vinyl rubs lightly against glass all the way down length of
glass. Press Draft•Stopper™ firmly in place along entire length when you are
satisfied it is correctly placed.
Reversing Pet Door Frame
If your sliding door opens “Left-to-
Right”, remove the “Ultra•Flex™”
Pet Door Frame (see Picture #27) and
reverse its position so Security Slide
(see Picture #28) faces the inside of
your home.
Page 6
24
25
26
27
28
Security Slide
Ultra•Flex™
Pet Door
Frame
Components
