9
VDV II Pro
158802.02
En
HUB (PORT) BLINK
To assist in confirming correct cabling of Ethernet installations, VDV II Pro can
generate Ethernet signalling on one end of a cable which causes the port LED of the
device connected to the other end to flash.
Hub (port) Blink is only available when the DATA port is selected.
To switch on Hub Blink:
•
Press the TOOLS button repeatedly until the Ethernet
Device Indicator flashes.
•
Press
or
o
The
symbol shows that Hub Blink is switched
on.
o
The Port Segment of the Ethernet Device
Indicator blinks.
o
Hub blinking continues until switched off or for
a maximum of 144 minutes.
To switch off Hub Blink:
•
Press the TOOLS button
o
The Ethernet Device Indicator Port Segment
stops flashing.
o
Hub Blink stops.
POWER OVER ETHERNET (PoE)
Power over Ethernet (PoE) is a method of supplying power to network devices such as
WiFi access points, IP cameras and Voice over IP (VoIP) phones using the Ethernet
wiring. Power is supplied by a PoE enabled switch port in response to a request from
the device requiring power.
When the DATA port is selected, and a PoE source is detected, VDV II Pro solicits PoE
from the source. If voltage is detected on the correct pins, PoE is indicated
.
Port
Service
Voltage Pins
DATA
PoE
>30v
1/2 – 3/6 or
4/5 – 7/8
Shows PoE
detected
Shows that Pins 3 and 6
are 40volts positive
compared to Pins 1 and 2
Shows Ethernet
device detected
Spinning Indicator shows
searching for PoE
Ethernet
Device
Indicator
Port
Segment
