Chapter 3
Settings
22
Setting the wiremap
This menu allows you to set the type of wiring.
1.
Select the menu point "Wiremap"
.
Option
Description
Cable Type
Selection of type of cable.
Display Pref
Selection of wiring schematic.
Xover Allowed
Permit cross-over cables.
Use Custom
NVP
Use own NVP value.
Custom NVP
3
Entry of cable-specific NVP value (Nominal
Velocity of Propagation) in percent, e.g. 79
for 79%.
2.
Select the desired option.
3.
Select the desired test parameters or enter the desired information with the
alphanumeric keys.
4.
Save the entry made with Apply. You can exit the menu without saving the
changes with
Escape
.
Setting the tone generator
This menu allows you to set the melody on the tone generator and the pin or pair to be
found.
1.
Select the menu point "ToneGen"
.
2.
Select the option
Tone
to set the melody.
3.
Set the desired option.
4.
Select the option
Wire Id
to set the pin or
pair to be found.
5.
Set the desired option.
6.
Save the entry made with Apply. You can exit
the menu without saving the changes with
Escape
.
3
Allows precise length measurement of the pair.
Figure 20: Wiremap
Figure 21: Tone generator
