Service Manual Ideal Air CG2 Commercial Grade Dehumidifier
Sunlight Supply, Inc.
3
1.
PRECAUTIONS
1.1 General Precautions
•
To prevent injury to the user, other people, and/or property damage, the instructions
should be followed.
•
Incorrect operation may cause harm or damage to people and/or property.
•
Before servicing this unit you must read this service manual.
1.2 Warnings
•
Always check for gas (refrigerant) leakage after installation and/or repair of product.
Low refrigerant levels may cause significant product failure. Tip: look for oil drips or oil
stains on or near the unit. This indicates a leak in the refrigerant system.
•
Securely install the drain hose to ensure that water is properly drained away from the
unit.
•
To avoid injury, use two or more people to lift and transport the product.
•
Operate dehumidifier in an upright position, only. When transporting the dehumidifier
on its side, allow the dehumidifier to stand upright for 30 minutes before switching ON.
This is necessary to allow the refrigerant system to stabilize and avoid system damage.
•
After removing the dehumidifier from its shipping container, visually check for signs of
damage. If there is evidence of damage, do not operate. Call the store you purchased
the unit from to discuss next steps. Do not discard packing, manuals, or any contents.
Original packaging and materials are required for any product return.
•
Do not disassemble or repair the product while plugged in.
1.3 Installation Precautions
Please follow these warnings during installation to prevent risk of fire or electrical shock:
•
Do not use a defective or underrated electrical circuit.
•
For electrical work, consider contacting a qualified electrician, or mechanical technician.
•
Always use an electrical plug that is grounded.
•
Always install on a dedicated circuit.
•
Use the correctly rated breaker, fuse or other over-‐current protection appropriate to the
unit, as specified by local electrical code.
•
Do not modify or extend the power cable.
•
Be careful when unpacking and installing the product. Sharp edges could cause injury. Be
especially careful of the enclosure edges and the fins on the refrigerant coils.
•
Do not install the product in a manner that could allow it to fall over.
If this unit falls over,
it increases risk of injury or damage.
•
Take care in placing/locating the unit to prevent power cord from being forcefully pulled
out or damaged during operation.
•
Do not place anything on the power cable. Do not use if the power cable becomes
damaged.
