![background image](http://html1.mh-extra.com/html/idatalink/maestro-ar/maestro-ar_install-manual_3581861053.webp)
ADS-AR-FOR02
maestro.idatalink.com
FORD FLEx 2013-2017
Automotive Data Solutions Inc. © 2017
4
INSTALLATION INSTRUCTIONS
BEFORE INSTALLING
• Update the aftermarket amplifi er with special fi rmware
to make it compatible with Maestro RR.
STEP 1
• Remove the factory amplifi er (refer to wire chart for
amplifi er location).
• Confi gure the 2 pin connectors on the AR-FO2 T-harness
as shown on the wiring diagram.
STEP 2
• Connect the factory amplifi er harnesses to the AR-FO2
T-harness.
STEP 3
• Connect the wires from the AR-FO2 T-harness to the
aftermarket amplifi er.
Note 1:
If you are running your own speaker wires from the
amplifi er to the speakers, this step is not necessary.
Note 2:
The amplifi er output colors and labels on the FO2 T-harness
do not correspond to the vehicle. For vehicle specifi c wiring
designation, see the wiring chart.
• Plug the connector from the AR-FO2 T-Harness into the
female adapter (supplied by Audison). Plus the adapter into
the aftermarket amplifi er.
• Plug the Data cable (supplied by Audison) to the data port
of the aftermarket amplifi er.
STEP 4
• Connect all the harnesses to the Maestro AR module.
Note 3:
The aftermarket amplifi er will not turn OFF with the key, it
will shut down when the vehicle goes to sleep.
Note 4:
The optical input source will be disabled when connected
to Maestro AR for Prima amplifi ers that have hardware
revision R2 or lower.
The optical input of the Prima Amplifi er will be used for
audio when the OEM radio source “AVINPUT” is used. The
volume knob will change the optical volume in the Prima
amplifi er in vR3 or higher.
• For technical assistance call 1-866-427-2999 or e-mail
“[email protected]”. Visit us at “maestro.idatalink.
com/support” and “www.12voltdata.com/forum/”
1