U.S. Patent No. 8,856,780
INSTALLATION MODE SELECTION
1
Press and release
programming button
to select installation mode.
2
Press and hold
programming button
until LED turns solid GREEN
to register selection.
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
TYPE 1 - MODULE PROGRAMMING PROCEDURE - 1 OF 2
1
Insert key 1 into ignition.
2
Turn key 1 to ON position.
ON
!
If the module’s LED begins to fl ash RED, verify the RX
and TX connections between the module and the vehicle.
!
If the module’s LED turns solid GREEN for 2 seconds,
the Module Programming Procedure is completed.
NOTE
I
To complete this procedure,
both OEM keys are required.
5
Remove key 1.
10
TIME RESTRICTI
º
N
Complete steps 10 to 13
within 5 SECONDS.
Remove key 2.
6
Insert key 2 into ignition.
7
Turn key 2 to ON position.
ON
8
Wait, LED will turn solid RED
then will turn OFF.
3
Wait, LED will turn solid RED
then will turn OFF.
11
Press and release programming
button.
È
IMPORTANT: READ NEXT PAGE !
9
Turn key 2 to OFF position.
OFF
4
Turn key 1 to OFF position.
OFF
È
TIME RESTRICTI
º
N COMING UP !
12
Insert key 2 into ignition.
Page 7 of 11
ADS-TB-FM3-EN
20141127
inStall GUide
www.idatalink.com
automotive data Solutions inc. © 2014
Transponder Bypass
Ford/LincoLn
Doc. No.: ##18230##
