U.S. Patent No. 8,856,780
INSTALLATION MODE SELECTION
1
Press and release
programming button
to select installation mode.
2
Press and hold
programming button
until LED turns solid GREEN
to register selection.
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
MODULE PROGRAMMING PROCEDURE - WITH KLON - 1 OF 2
1
Open driver door.
5
Press and hold start button to
ON position.
Æ
7
Push start button once [1x] to
OFF position.
x1
Æ
4
Insert keyfob 1 in keyport.
(Top part)
Æ
11
Insert keyfob 1 in keyport.
(Top part)
Æ
10
Remove keyfob 1 from keyport.
(Top part)
Æ
2
Remove valet key from keyfob 1.
Æ
Æ
3
Remove batteries from keyfob 1.
(Bottom part)
Æ
13
Wait, LED will turn solid RED
then will fl ash GREEN rapidly.
È
IMPORTANT: READ NEXT PAGE !
12
Press and release
programming button.
8
Press and release
programming button.
9
Wait, LED will turn solid RED
then will fl ash GREEN twice [2x].
x2
6
If LED fl ashes GREEN once [1x].
(This may take up to 10 seconds)
Proceed to the following step.
If LED fl ashes RED once [1x]
then fl ashes GREEN four times
[4x]. Use the DL-VO4 solution.
x1
Page 5 of 8
ADS-AL(DL)-VO3-EN
20160302
INSTALL GUIDE
WWW.IDATALINK.COM
Automotive Data Solutions Inc. © 2016
Doorlock Interface
VolVo
Doc. No.: ##27133##
