U.S. Patent No. 8,856,780
MODULE PROGRAMMING PROCEDURE
14
Module Programming
Procedure completed.
NOTE
I
When programming, only one keyfob will be used. The other
one must be located at least 10 feet away from the vehicle.
8
WARNING:
Connect power fi rst.
Connect module to vehicle.
Æ
6
WARNING:
Disconnect power last.
Disconnect module from vehicle.
ÆÆ
7
Connect module to computer
and proceed with extended
programming.
Æ
5
Push start button once [1x] to
OFF position.
ENGINE
START
STOP
Æ
x1
1
Push start button once [2x] to
ON position.
ENGINE
START
STOP
Æ
x2
9
Push start button once [2x] to
ON position.
ENGINE
START
STOP
Æ
x2
13
Push start button once [1x] to
OFF position.
ENGINE
START
STOP
Æ
x1
3
Start engine.
ENGINE
START
STOP
Æ
11
Start engine.
ENGINE
START
STOP
Æ
12
Wait, LED will turn solid
GREEN.
4
Wait, LED will fl ash GREEN
rapidly.
2
LED will turn solid RED.
10
LED will turn solid RED.
INSTALLATION MODE SELECTION
1
Press and release
programming button
to select installation mode.
2
Press and hold
programming button
until LED turns solid GREEN
to register selection.
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
Page 26 of 28
ADS-AL(DL)-SUB2-EN
20171211
INSTALL GUIDE
WWW.IDATALINK.COM
Automotive Data Solutions Inc. © 2017
Doorlock Interface
SUBARU
Doc. No.: ##46348##
