How do you program a scanner with this manual?
EZ
One Shot
Setting Procedure.
R
HOW TO SETUP THE PARAMETER
.
2. Most programming procedures need only One Shot Setting excepts :
Preamble, Postamble, Min / Max Lenght, Accuracy Adjustment.
Set A Data ( Insert data between Two Codabar : CX-Codabar,
ABC Codabar, Codabar Coupling) , Define EAN128.
( See related
pages for detail instructions). The are shown as follow:
.
1. Aim the scanner directly to the bar code ( function/ parameter ) you
want to set,
1.1. Then you will hear TWO beep sounds, mean the NEW parameter
is defined or updated into the memory processor.
1.2. Thus, the whole set up procedure is over.
2.1.Preamble / Postamble
Scan
CLR PRE/POSTAMBLE Scan PREAMBLE/ POSTAMBLE
>>>> Scan any alphanumeric from Full ASCII Table from
Group 32 ~Group40. >>>> Scan
2.2.Min Length / Max Length:
Scan
2.3.Accuracy Adjustment:
Scan ACCURACY ADJUSTMENT >>>> Scan One digit number
from Numeric Table from APPENDIX 1 >>>>
( Max 16 digits ).
PREAMBLE or POSTAMBLE
.
MIN LENGTH or MAX LENGTH >>>> Scan
TWO
digits number
from Appendix 1. ( next pages to the related setting pages ) >>>>
Scan MIN LENGTH or MAX LENGTH
.
Scan ACCURACY
ADJUSTMENT.
2.4.Customer configuration ID -- ( Example: Code 39 )
Scan Code39 Set ID from Group8 ~ Group9 >>>> Scan alphanumeric
( Max TWO digits ) of FULL ASCII ( Code 39 ) Table from Group32 ~
Group40. >>>> Scan Code39 Set ID from Group8.
2.5.
Set A Data - ( CX-Codabar, ABC Codabar, Codabar Coupling).
Scan
Set A Data.
>>>> Scan any alphanumeric data ( Max ONE digit )
from FULL ASCII (Code 39) Table from Group32 ~ Group 40 >>>>>
Scan
Set A Data.
2.6 REMARK:
2.6.1. Most setting procedures of above-mentioned need TRIPLE setting.
2.6.2. Scanners will beep thrree rapid beeps"Ti", "Ti",Ti" to remind incomplete
of Setting, please go on to complete the setting.
2.6.3. If you make a mistake, forget where the steps to exit, Scan Reset
(. P023$) at below for resetting.
3. SYMBOL AND ABBREVIATION:
3.1. DEFAULT Setting:
All Default's Parameters are indicated in bold type and underlined
Characters. The Font of the Characters is ARIAL BLACK.
3.2. CD = Check Digits.
3.3. CDV = Check Digits Verification
.
. A001$
DEFAULT
. P 023$
RESET
Setting code
8
Summary of Contents for Econoscan
