ID Lock Z-Wave Module Technical manual for FW 1.6
June 20
th
2019
idlock.no
idlock.no/zwave
ID Lock
6
3.3.
ID Lock 150
3.3.1.
Inclusion and Exclusion (Adding or removing)
For inclusion (puts your device in inclusion mode) of ID Lock 150 first set your
designated Z-Wave controller in inclusion mode then press and hold the
Key Button [A] until keypad is activated whilst the door lock is open and unlocked.
1.
Release button [A] and enter Master PIN [1234], followed by [*] on keypad.
2.
Press digit [2], followed by [*] to enter settings menu.
3.
Press digit [5] to start inclusion or exclusion.
Inclusion/exclusion mode starts immediately and is indicated by flashing blue LEDs.
3.3.2.
Z-Wave module device reset
For Z-Wave local reset follow same procedure except use digit [0] instead of [5].
Take notice that if the Z-Wave module is included in a Z-Wave network the door lock
will return to factory settings when performing a local reset.
Reset starts immediately and is indicated by flashing blue LEDs.
Warning!
After Z-Wave local reset the device might have to be excluded before a new inclusion.
This function is made available by design only to be used if your module
does no longer function properly or if your Z-Wave controller is lost.
