Manual IB-2812CL-U3
Manual IB-2812CL-U3
Starting the clone process
• Connect the IB-2812CL-U3 via an optional power supply or the delivered cable to the
corresponding port of your host computer.
• When the IB-2812CL-U3 has been plugged in correctly the Power LED will turn on blue!
• To start the clone process, press and hold the „Clone“ button for around 10 seconds.
If the selection was successful, the 0-50% and 50-100% LED will blink with a high
frequency. Press the Clone button again to start the clone mode. If the starting process
successful, only the 0-50% LED frequency will blink to show the cloning progress.
• To interrupt the cloning progress just press the „Reset” button.
• The clone process is completed when both progress LEDs are
permanently green (not flashing).
• To switch from clone mode to PC mode, simply press the „Reset“ button.
The SSDs are then registered in the operating system.
