10
4.5 HDD cloning-function
• Before the cloning process, please remove the USB cable from the device.
• Insert the source drive into slot HDD1 (source) and the target drive to slot HDD2 (target).
• Press Power button to power on the device. Power LED will lit in blue as PC mode.
• Press and hold the MODE button for 3 seconds to change to clone mode. Power LED will
• change from Blue to Red.
• Press the Start button. Both HDD1 and HDD2 LED will start to blink. The first LED of progress indicator (25%)
will start to blink as well. The cloning is in process.
• When the status indicator reaches 100% and stops blinking, your cloning process is completed.
• Press power button to turn off the power then remove the HDDs.
4.6 Advices to the cloning-function
The clone function creates an identical copy of your hard drive – no need to connect to any compu-
ter. You can copy a bootable system disk without additional software or professional skills.
Since the cloning process copies every single byte of the source HDD the process may take several hours depending
on the HDD capacity.
After the cloning process is completed, in some cases the computer may not be able to identify
both drives since they are assigned to the same drive letter. To separate the drives, you must assign
one drive to a new drive letter under "disk management" (Windows).
If only one drive is plugged into HDD1 (source), there will be no action when you press the start button.
The target HDD (HDD2) must be of the same size or bigger than the source HDD (HDD1).
If the targets drive (HDD2) is smaller than the source drive (HDD1), after pressing the start button, both HDD1 and
HDD2 LED will blink in high frequency. Please press the power button to turn off the power and remove the HDDs.
You may create a new volume with the remaining space on the target HDD after cloning.
Manual IB-121CL-C31
Handbuch IB-121CL-C31
