LAPTOP TRAY ARM INSTALLATION
LAPTOP TRAY ARM INSTALLATION - 6/1/20
IF MOUNTING TO A DESK
IF MOUNTING
TO A POLE
WARNING:
Provided hook-and-loop fastener strips are intended to hold laptop in place when tray is level. They are NOT intended to secure the laptop
when tray is flipped up into stowed position. CAUTION: Heat generated by some laptops may soften the glue of the hook-and-loop fasteners.
Screw stud
into desk mount
ATTACH POLE CLAMP TO POLE
Using the 1/4″ hex key,
separate the two halves of
pole mount as shown, place
around pole at the desired
height and reassemble.
ULTRA CORD MANAGEMENT
1. Prepare all cables to route within the arm by placing them
near cavity of arm and bundling together if necessary.
2. Remove cover by unscrewing four screws.
Screws are captured by the cover so they cannot fall out.
Once screws are disengaged, pull cover out of arm.
3. Place cables within the channel. Do not block
the holes where screws will engage in arm.
4. Replace cover and tighten screws. Cables should be
able to pull through to desired position if necessary.
Desk Mount
Part Number
Stud
Length
Maximum
Desk Thickness
D0
3.50”
2.47”
D1
3.50”
1.87”
D3
5.50”
1.87”
D5
7.50”
1.87”
D7
10.50”
2.38”
Drill a 3/8 hole through the horizontal mounting
surface. Push the All Thread bolt on desk mount
assembly through the hole in the horizontal surface.
Slide large mounting washer over the bolt from
underneath and secure in place with 3/8 nylock nut.
NOTICE: ICWUSA.COM, Inc. provides the appropriate hardware fasteners to
match the majority if not all standard monitors and devices. It is the responsibility
of the installer / integrator to ensure that the screws and fasteners have the
adequate thread engagement. The rule of thumb is that the thread depth is
greater than the diameter of the hole or 4 full turns of 360 degrees of thread
engagement. It is also the responsibility of the installer / integrator to ensure that
they do not damage the monitor or device by using a screw or fastener that is too
long for hole and therefore damaging the unit by inserting too far.
When cleaning your ICW mounting unit please follow the points below. Proper
cleaning of the mounting device will help assure proper function and extend the
life of the unit.
1. Any general cleaner is acceptable except degreasers are not recommended near
the bearing entrances.
2. Spray cleaner or water on a soft cloth or paper towel and then wipe down
the mounts.
3. Do not spray directly at the bearing seams (located at all swivel points) as this could
reduce the life of the bearings.
CLEANING OF THE ICW MOUNTING DEVICE
Desk
Desk
Washer
Nylock
ULTRA CORD MANAGEMENT
