ICWUSA.com, Inc.
If you have any questions, please call 1-800-558-4435
ULTRA ARM INSTRUCTIONS
ULTRA ARM INSTRUCTIONS - rev 12/06/2012 mf
ULTRA WIRE
MANAGEMENT
[1] Prepare all
cables to route
within the arm by
placing them
near cavity of arm
and bundling together if necessary. Remove
cover by unscrewing two socket head cap
screws. Screws are captured by the cover
so they cannot fall out. Once screws are
disengaged, pull cover out of arm.
1
2
3
[2] Place cables over
cover and within the
channels. Do not block
the hole where screws
will engage in arm.
[3] Replace cover and
tighten screws. Cables
should be able to pull
through to desired
position if necessary.
ATTACH UL500 TO W2
Attach to UL500 to W2 wall
mount using 3/8 bolt assembly
and 1” bearing assembly
provided. Insert bolt assembly up
through wall ear. Place 1” bearing
assembly over bolt on other side
of wall ear. Place UL500 over bolt
and bearing and turn bolt until
UL500 is secure and smoothly
turns against the bearing.
Beauty
cap
UL500
W2
1” ID bearing
assembly
3/8 bolt
assembly with
3/8 ID bearing
ATTACH PARALINK TO W2
Attach to Paralink to W2 wall
mount using 3/8 bolt assembly
and 1” bearing assembly
provided. Insert bolt assembly
up through wall ear. Place 1”
bearing assembly over bolt on
other side of wall ear. Place
Paralink over bolt and bearing
and turn bolt until Paralink is
secure and smoothly turns
against the bearing.
Beauty
cap
Paralink
W2
1” ID bearing
assembly
3/8 bolt
assembly with
3/8 ID bearing
ATTACH UL510 TO W2
Attach to UL510 to W2 wall
mount using 3/8 bolt assembly
and 1” bearing assembly
provided. Insert bolt assembly
up through wall ear. Place 1”
bearing assembly over bolt on
other side of wall ear. Place
UL510 over bolt and bearing
and turn bolt until UL510 is
secure and smoothly turns
against the bearing.
1” ID bearing
assembly
3/8 bolt
assembly with
3/8 ID bearing
Beauty
cap
UL510
W2
