Programming Custom Operation
To customize the operation of a wireless receiver unit to match your requirements:
⦁
Connect a terminal program such as HyperTerminal with the RS-232 settings shown above.
⦁
Press
Esc
to display the main programming menu.
Receiver Mode Menu
To enter the mode menu, type the shortcut:
Esc, E, Enter
Type
1, Enter
to toggle between the following receiver modes:
⦁
ICT Pass Through Mode (default mode)
: This setting allows the receiver to pass credential data over the
Wiegand or RS-232 ports. The receiver will accept and pass on button presses from all ICT wireless transmitter
devices.
⦁
Custom Site Code Mode
: The receiver will operate in standalone configuration. It will only accept button
presses from ICT wireless transmitter devices that match a fixed site code. This can be programmed in the
Site
Code
menu.
⦁
Individual User Mode
: The receiver will operate in standalone configuration. Only button presses from
specifically programmed transmitters are accepted. Users can be programmed in the
User Programming
menu, or by reading remotes (quick user programming).
User Menu
This menu is only available when the receiver mode is set to
Individual User Mode
.
To enter the user menu, type the shortcut:
Esc, F, Enter
The wireless receiver can store up to 600 individual Transmitter ID numbers for standalone use.
Adding/Editing Users
1.
Type
1, Enter
to add or edit a user.
2.
To add a new user, type an unused
user number
(from 1-600). To edit an existing user, type the
user number
for that user then press
Enter
.
3.
To assign a transmitter to the user, press any button on the transmitter or type in the Transmitter ID.
To delete a user, type
0
instead of a Transmitter ID.
4.
Press
Enter
to save your settings.
5.
Enter the next
user number
, or press
Esc
to stop programming.
The module will not display previously programmed user numbers. It is recommended that you make a record of
these when programming.
Configuring Range Mode
The wireless receiver also has a range mode, which restricts the receiver to accept only Transmitter IDs within a
specified range. This allows you to quickly define which transmitters will be accepted by the module in standalone
configuration, without programming all of the individual users.
RF-RCVR-433 | Wireless 433MHz Receiver | Installation Manual
8