Modular Power Series
855-340-004_Rev2.0_Instruction Manual
Page
39
of 81
tripped due to an overcurrent event. Will show OFF if the output is
disabled in the GUI.
Alarm Status
: Shows status of the LDM. (Current, Alarm or OK).
4.2.2 SETTINGS & CONTOL
This tab is used to adjust the System Output Settings.
DC Output Status
On/Off Buttons
: Use these to remotely disable the system output by
shutting off all power modules. The default setting is Enabled.
Auto-Restart Button
: Use this button to momentarily shut off the main
output, and then restart automatically after a time delay (set in the "Auto-
Restart Delay" field) This feature can be used to remotely force
connected equipment to re-boot.
Output Settings
Output Voltage
: Set the system "Output Voltage" to match the float
voltage requirement for the external battery. The default setting varies
based on the power modules installed (see Table 9).
