ELECTRIC BICYCLE METER KT—LCD3 Product User Manual
- 33 -
2
Default value-1V
Default value-1V
Default value-1V
3
Default value-0.5V
Default
value-0.5V
Default
value-0.5V
4
Default value 20V
Default value
30V
Default value
40V
5
Default value+0.5V
Default
value+0.5V
Default
value+0.5V
6
Default value+1V
Default value+1V
Default value+1V
7
Default value+1.5V
Default
value+1.5V
Default
value+1.5V
C12 default value is 4, namely, controller minimum operating voltage (voltage
shortage value); when setting is 5, the default value plus 0.5V, when setting is 4, the
default value minus 0.5Vand so on.
After finishing C12 parameter setting, hold
button (SW) shortly to save current
set values and enter C1 parameter setting interface again. Or hold
button (SW) long
for about 2 seconds to exit C parameter setting environment and return to the display 1.
○
Exit C Parameter Setting
Among the twelve C parameter settings, when each parameter setting is completed, if
held
button (SW) long for about 2 seconds, all can exit the setting environment and
return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.
Parameter Copy
Set parameters (include general project parameter, P parameter and C parameter) of
all KT-LCD3 meter produced by our company according to requirements, and set the meter
to be a data source according to the method of "C11meter attribute selection mode".