Page 2-1
Manual 00650-519-1
Chapter 2: Installation
The software provided with this card is contained on either one CD or multiple diskettes and must
be installed onto your hard disk prior to use. To do this, perform the following steps as
appropriate for your software format and operating system. Substitute the appropriate drive letter
for your CD-ROM or disk drive where you see d: or a: respectively in the examples below.
CD Installation
DOS/WIN3.x
1.
Place the CD into your CD-ROM drive.
2.
Type
d:K
to change the active drive to the CD-ROM drive.
3.
Type
installK
to run the install program.
4.
Follow the on-screen prompts to install the software for this card.
WIN95/98/NT
1.
Place the CD into your CD-ROM drive.
2.
The CD should automatically run the install program after 30 seconds. If the install
program does not run, click START | RUN and type d:install, click OK or press
K
.
3.
Follow the on-screen prompts to install the software for this card.
3.5-Inch Diskette Installation
As with any software package, you should make backup copies for everyday use and store your
original master diskettes in a safe location. The easiest way to make a backup copy is to use the
DOS DISKCOPY utility.
In a single-drive system, the command is:
diskcopy a: a:K
You will need to swap disks as requested by the system.
In a two-disk system, the command is:
diskcopy a: b:K
This will copy the contents of the master disk in drive A to the backup disk in drive B.
