Auto Sentry® Petro - Installation Guide
26
System Wiring
Auto Sentry® Petro AC Power Terminations
Figure 20. AC Power Terminations and Program Sense Car
Programming Sonic Sensor for Sense Car
NOTE:
THIS PROGRAMMING GUIDE IS FOR THE ROUND WHITE/GREEN SONIC SENSOR NOT THE
ORANGE SENSOR.
1) Put something in front of the sensor the same distance away from the Auto Sentry Petro where
a car would normally be when parked at the payment terminal. (A metal sign works best or
something similar).
2) With the object in place, touch the white programming wire to the +24 orange terminal block,
and the sensor flashes yellow. Hold until it flashes red, and then hold for a few more seconds.
3) Move the wire off of the +24 orange terminal block.
4) Move the object away from the area.
5) Touch the white programming wire to the -24 blue terminal block.
6) Sensor should flash red.
7) Move the wire off of the -24 blue terminal block.
8) Test the sensor, you should see the sense car on the PIO/SIO board light up.
If no signal, you can remove 3P9 cable and jump pins 3 and 4 on the board and check car sense
light.
ICS SUPPLIED
14/3 SHIELDED
TO A 15 AMP BREAKER ON
THE CUSTOMERR S MAIN
SERVICE ELECTRICAL PANEL
WIRED BY AN ELECTRICIAN
G
L
Program
Sense Car
Car Sense
-24VDC +24VDC
GREEN CONDUCTOR
(GROUND) FROM 14/3
SHIELDED
WHITE CONDUCTOR
(NEUTRAL) FROM 14/3
SHIELDED
BLACK CONDUCTOR (LINE)
FROM 14/3 SHIELDED
10
A
***
NOTE:
The wiring and terminations are the responsibility of the car wash
owners, electrician, and/or supplied contractor. Please have an electrician and/or
car wash owner supplied contractor complete all of the site s wiring pulls and
terminations prior to the ICS technician coming onsite.***
Auto Sentry Petro
Ground Lug
Fused connection for
the Line voltage side
of the Auto Sentry
Petro Power
N
N
L
Fused connection
for the Nuetral side
of the Auto Sentry
Petro Power