Installation guide
Before you can install the Ranger 2104, you need to prepare your site.
1.
Determine where the computer is to be located and set up the computer.
2.
Determine where you want to locate the USB device(s).
3.
If you are using surface cabling, ensure you have enough Category 5e UTP cabling to connect the two
locations to the maximum distance of 100m supported by device.
OR
If you are using premise cabling, ensure Category 5e UTP cabling is installed between the two
locations, with Category 5e information outlets located near both the computer and the USB
device(s).
Installing the LEX unit
1.
Place the LEX unit near the computer.
2.
Plug the Type A male connector on the LEX into a USB port on the computer.
Installing the REX unit
1.
Place the REX unit near the USB device(s).
2.
Plug the power adapter into a suitable AC outlet.
3.
Connect the power adapter to the REX unit.
Use only the DC adapters supplied with the Ranger. Use of substitute adapters may cause permanent
damage to the system and will void the warranty.
6
USB extension up to 100m Cat 5 (or better) cable
