2A. INSTALLATION STEPS
Please follow the steps listed below to install the device. Please refer
to Figure 2-1 for reference.
MARGIN
GUIDES
Stay within the yellow
box. Do not let text go
beyond, instead move
to the next column or
start a new page.
3
|
www.icrealtime.com
Figure 2-1
Step 1
Take the device position map and place it on the mounting
surface. Drill holes using the position map as a guide. Be sure to set
the angle accordingly to the cable exit.
Step 2
Place the anchor screws.
Step 3
Drill the cable exit and pull the wires through the cable exit. If
using the side exit, remove the side exit panel on the mount.
Step 4
Take the camera base mount, thread the cables through it. If
using the side exit, route the cable through the side exit access.
Install the mounting screws through the base mount and into the
anchor screws securely.
Step 5
Connect the necessary wires to the camera and install the
camera on to the base mount.
Step 6
Make sure all screws are securely fastened. See the next page
for adjusting lens angle.
