ICRealtime EDGE4T, User Manual

Page: 42 / 245

33
4 Overview of Navigation and Controls
4.1 Boot up and Shutdown
4.1.1 Boot up
Before the boot up, please make sure:

The rated input voltage matches the device power on-off button. Please make sure
the power wire connection is OK. Then click the power on-off button.

Always use the stable current, if necessary UPS is a best alternative measure.
Please follow the steps listed below to boot up the device.

Connect the device to the monitor and then connect a mouse.

Connect power cable.

Click the power button at the front or rear panel and then boot up the device. After
device booted up, the system is in multiple-channel display mode by default.
4.1.2 Shutdown
Note

When you see corresponding dialogue box “System is shutting down…” Do not click
power on-off button directly.

Do not unplug the power cable or click power on-off button to shutdown device
directly when device is running (especially when it is recording.)
There are three ways for you to log out.
a) Main menu ( RECOMMENDED )
From Main Menu->Shutdown, select shutdown from dropdown list.
Click OK button, you can see device shuts down.
b) From power on-off button on the front panel or remote control
Press the power on-off button on the DVR front panel or remote control for more than 3
seconds to shutdown the device.
c) From power on-off button on the rear panel.
4.1.3 Auto Resume after Power Failure
The system can automatically backup video and resume previous working status after
power failure.
4.1.4 Replace Button Battery
Please make sure to use the same battery model if possible.
We recommend replace battery regularly (such as one-year) to guarantee system time
accuracy.
Note:
Before replacement, please save the system setup, otherwise, you may lose the
data completely!