1
1
Introduction
Welcome to the JUKI-3711P/3712 Pentium® III, Celeron Single
Board Computer. The JUKI-3711P/3712 board is a PCISA/ISA
form factor board, which comes equipped with high performance
Pentium® III, Celeron™, VIA Cyrix®
Ⅲ
Processor and advanced
high performance multi-mode I/O, designed for the system
manufacturers, integrators, or VARs that want to provide all the
performance, reliability, and quality at a reasonable price.
In addition, the JUKI-3711P/3712 provides C&T MI69K VGA
chip . The VGA which provides up to 1280x1024 resolution. The
VGA memory is share main memory.
An advanced high performance super AT I/O chip – Winbond
W83977TF-AW is used in the JUKI-3711P/3712 board. Both on-
chip UARTs are compatible with the NS16C550. The parallel port
and IDE interface are compatible with IBM PC/AT architecture's.
JUKI-3711P/3712 uses Intel 82559 Fast Ethernet Multifunction
PCI Controller as LAN controller. The 82559 is a fully integrated
10BASE-T/100BASE-TX LAN solution with high performance
networking functions and low power features.
JUKI-3711P/3712 uses the advanced VIA Chipset,
82C693A/82C596B.
2
1.1 Specifications :
•
CPU
: Celeron™ 300 - 566Mhz or above Processor
Pentium® III(FC-PGA) 450 - 866Mhz or above Processor
VIA Cyrix®
Ⅲ
466Mhz or above Processor
•
FSB
: 66/100/133MHz
•
Bus
: PCISA Bus, compatible to Jump PISA Ver. 1.07(JUKI-3711P)
: ISA Bus(JUKI-3712)
•
DMA channels
: 7
•
Interrupt levels
: 15
•
Chipset
: VIA 82C693A/82C596B
•
RAM memory
: Single 168-pin DIMM sockets support SDRAM
module. The max memory is up to 256MB.
•
Ultra ATA66
IDE Interface
: Two PCI Enhance IDE hard drives.
The south bridge supports Ultra ATA66 IDE interface.
•
Floppy disk drive interface
: Single 2.88 MB, 1.44MB, 1.2MB,
720KB, or 360KB floppy disk drive.
•
Two high speed Serial ports
: NS16C550 compatible UARTs, with
one RS232/RS422/RS485 multifunction serial port. RS485
provides the function of auto-direction.
•
Bi-directional Parallel Port:
compatible with
ECP and EPP
•
Hardware Monitoring:
W83L784R to monitor power supply voltage
and fan speed status.
•
IrDA port :
Support Serial Infrared(SIR) and Amplitude Shift
Keyed IR(ASKIR) interface.
•
USB port :
Support two USB ports for future expansion. USB 1.1.
•
WatchDog Timer
: can be set by 1,2,3…255 seconds period.
Reset or NMI was generated when CPU did not periodically
trigger the timer. Your program use hex 843 and 443 to control
the watch-dog and generate a system reset.
