35
Init Display First
This item allows you to decide to activate the PCI Slot or AGP for a VGA card
first.
Options: PCI Slot,AGP
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard drive supports block mode (most new drives do),
enable this for automatic detection of the optimal number of block read/writes
per sector the drive can support.
Options: Enabled, Disabled
Onboard FDC Controller
Enable this if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system
has no floppy drive, disable this option.
OnChip USB
This should be enabled if your system has a USB installed on the system board
and you want to use it. If you are using an add-on USB controller, this needs
to be disabled.
Options: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second serial
ports.
Options: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART 2 Mode
This item allows you to select which mode for the Onboard Serial Port 2.
Options: Standard, HPSIR, ASKIR.
IR Function Duplex
This item allows you to select the IR half/full duplex function.
Options: Half, Full.
TX, RX inverting enable
This item allows you to enable the TX, RX inverting for different hardware
requirements. We do not recommend changing this option as system errors
may result if the setting is incorrect.
Options: No, No/ No, Yes(Default)/ Yes, No/ Yes, Yes.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O address
setting.
Options: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled
