ICP DAS USA Zigbee ZT-2060, Quick Start Manual, Page: 2 / 11

ZT-2060 Zigbee 6-ch DI, 4-ch Relay Output Module - QuickStart (Jan/2018)
ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717
2
2
Preparing the Device
1.
Refer the chapter 3. to configure the DIP switch of ZT-2060 I/O device.
2.
Install the ZT Configuration Utility to configure the ZT-2060 coordinator.
CD:
\
Napdos
\
ZigBee
\
ZT_Series
\
Utility
http://ftp.icpdas.com/pub/cd/usbcd/nap
dos/zigbee/zt_series/utility
3. Power Supply: +10 ~ +30 V
DC
3
Setting up the ZT‐2060 DIO Device
3.1 Introduction to the Configuration Parameters
A. “Pan ID” parameter is the group identity for a ZigBee network, and
must the same for all devices in the same ZigBee network.
“Address/Node ID” parameter is the individed identity of a specific
the ZigBee module, and must be unique for each device connected the
same ZigBee network.
B. “RF Channel” parameter indicates the radio frequency channel, and must
be set to the same value as other modules on the same ZigBee network.
Channel 0x00 0x01 …… 0x0F
Frequency(MHz) 2405 2410 …… 2480
※ RF channels 0x04, 0x09, 0x0E or 0x0F are recommended because they do
not overlap with the Wi-Fi frequencies based.
802.11b/g 802.11b/g 802.11b/g
Channel 1 Channel 6 Channel 11
2400
00 01 02 03 04 05 06 07 08 09 0A 0B 0C 0D 0E 0F
2485
MHz MHz
802.11b/g Channel (North America)