ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
115
After all Input Register settings of the Modbus RTU module are
completed, click “OK” button to save the changes.
The Holding Register Setting of Modbus RTU Module
The Modbus RTU Slave module Holding Register Setting page is
shown as follow:
Figure7-49 :
Holding Register Setting Page
The settings are as below:
Data Model: PMC/PMD offers 4 Data Model selections to
match the Modbus RTU Slave module configuration. Please
refer to the above section “The Coil Output Setting of Modbus
RTU Module” for detailed information. In this case please
select ” Holding Register (4x)”.
Start Address: Allows to set up the starting address of Holding
Register(4x) on the Modbus RTU Slave module you would like
to retrieve.
Data Number: After finishing the Start Address setting, specify
the Data Number, it is the number of Holding Register data you
would like to retrieve from the Start Address.
Type: The system support 6 kinds of data type setting for
Summary of Contents for PMC-523 Series
Page 1: ...ICP DAS PMC 523x PMC 224x PMD Power Meter Concentrator Series User Manual Version 3 2 4...
Page 165: ...ICP DAS PMC 523x PMC 224x PMD Series User Manual 150 Figure9 14 The Import of MQTT Topic...
Page 205: ...ICP DAS PMC 523x PMC 224x PMD Series User Manual 190 Figure10 53 PUE Setting Page 2...
