7. Please press “Exit Toolkit” to exist the
software. And find the quick start demo at
C:\ICPDAS\PISO-DNS100\Demo\QuickStart
Demo\Project1.exe. After executing the demo,
it would also search the PISO-DNS100 boards
in your PC.
5. If the users have added the slave device (ID=
12) successfully, you would see two dialog
with successful message. The users would
find out that there was a new item in the
“Devices in EEPROM” field.
PISO-DNS100 Quick Start Manual (Version 1.0, Sep/2008) ------------
7
8. Please click “ActiveBoard” button to active
the specific board which you have selected in
the “Board ID” field. Note that the value of
“Board ID” must the same with the previous
selection of the toolkit.
6. Clicking the “Reset Firmware” button to
reset the firmware. This would make your
new setting enable. After clicking this
button, the users should wait for 1 or 2
seconds to make the firmware boot up
completely. When booting up successfully,
the toolkit would upload all information
from the EEPROM again.
