PCI-82x Series Cards
Multifunction Boards
User Manual, Ver. 1.5, Jan. 2017, PMH-024-15, Page: 35
5
Testing the PCI-822/826 Series Card
This chapter provides detailed information about the
“Self-Test”
process, which is used to confirm
that PCI-822/826 Series card is operating correctly. Before beginning the
“Self-Test”
process, ensure
that both the hardware and driver installation procedures are fully completed. For detailed
information about the hardware and driver installation, refer to
Chapter 3 Hardware Installation
Chapter 4 Software Installation
5.1
Self-Test Wiring
The following is a description of how to configure the wiring in order to perform the “Self-Test”
procedures for the Digital Input and Digital Output. Refer to the appropriate descriptions for
PCI-822/826 Series cards in Sections 5.1.1 to 5.1.3 for more detailed information.
5.1.1 Digital Input/Output Test Wiring
Preparing the device:
Before beginning the
“Self-Test”
procedure, ensure that the following items are available:
A CA-2002 cable
(Website:
http://www.icpdas.com/products/Accessories/cable/cable_selection.htm
Step 1:
Ensure that
the
JP4 jumper (DIO-S0)
on the PCI-822/826 card is set to the
“soft” position
.
Section 2.2.4 JP4 Digital I/O Mode
for more detailed information.
Note: The direction of the DI/O ports are controlled by software when the
“software Program
Mode”
option is selected.
