ICP CON I-7590, Quick Start Manual

Page: 4 / 8

I-7590 Quick Start v1.00, July 29, 2014 -------------------------------------
4
4. LED Indicators
Description PWR MTX MRX
Power On (+10 ~ +30 V
DC
) ON -- --
M-Bus message is transmitted success
ON ON OFF
M-Bus message is received success ON OFF ON
Update firmware mode ON ON ON
5. Rotary Switch
The I-7590 has two rotary switches for the configuration of the M-Bus Baud
rate and serial port Baud rate. The following table describes the mapping table
between the rotary switches and Baud rate. After changing the configuration of
the rotary switches, the I-7590 needs to reboot to enable the new setting.
Switch Baud rate (bps) Format
0 300
M-Bus Port: 8, e, 1
Serial Port: 8, n, 1
1 600
2 1200
3 2400
4 4800
5 9600
6 19200
7 38400
8 57600
9 115200
A ~ F User-defined User-defined
6. DIP Switch
The DIP switch described in the section 1 is used to update firmware and
configure user-defined Baud rate. The configuration would be as follows. After
changing the configuration of the DIP switch, the I-7590 needs to reboot to
enable the new setting.
Init Pin Mode Pin Description
OFF OFF Operation Mode
OFF ON Configure Mode (refer to section 7)
ON -- Update Firmware Mode(refer to section 9)