PPC-104T User’s Manual
IUMPPC104T-01 Ver.1.0B Jun, 2016
10
1.5 Panel Mounting Instruction
1. Cut a mounting hole in the panel. (Refer to PPC
‐
104T Dimensions on page
11~12.) (Note 1)
2. Check and remove the twelve M3 screws in a diagonal pattern as image below if
necessary.
3. Place PPC
‐
104T face
‐
down on a clean, flat surface.
4. Slide the panel cutout around the back of PPC
‐
104T, until the panel rests
directly on the gasket. Make sure the screw holes align with the screw holes on
PPC
‐
104T.
5. The screw size is M3*L (L=wall thi 6.0mm) (Note 2)
6. Insert all twelve M3 screws into the screw holes. (Note 2)
7. Finger-tighten the M3 screws. Finish tightening the M3 screws in a diagonal
pattern using an M3 screw driver (see the image as below); maximum torque
1.18Nm (12 kgf
‐
cm).
○
1
○
2
○
3
○
4
○
5
○
9
○
7
○
12
○
11
○
10
○
8
○
6
