11
PDX2-090T DM&P Vortex86DX2 Panel PC with 9” WSVGA TFT LCD
1.5 Panel Mounting Instruction
1.
Cut a mounting hole in the panel. (Refer to PDX2‐090T Dimensions
on page 7) (Note 1)
2.
Check and remove the twelve M3 screws in a diagonal pattern as
image below if necessary.
3.
Place PDX2‐090T face‐down on a clean, flat surface.
4.
Slide the panel cutout around the back of PDX2‐090T, until the panel
rests directly on the gasket. Make sure the screw holes align with the
screw holes on PDX2‐090T.
5.
The screw size is M3*L (L=wall thi 6.0mm) (Note 2)
6.
Insert all twelve M3 screws into the screw holes. (Note 2)
7.
Finger-tighten the M3 screws. Finish tightening the M3 screws in a
diagonal pattern using an M3 screw driver (see the image as below);
maximum torque 1.18Nm (12 kgf‐cm).
