iCool LITE Owner'S Manual Download Page 10

Page: 10 / 18

iCool Lite

The pool temperature window shows the actual water temperature
returning from the pool. This will vary slightly to the actual temperature
in the pool because for safety reasons the electronic sensor is in the
cooling unit not in the pool. It accurately reads the actual temperature
of the water that is returning to the pool.

The actual pool temperature will be slightly different depending on your
particular setup. The temperature inside your iCool is always accurately
maintained but if you want to maintain an actual pool temperature

within 1 degree you can simply set an offset amount to compensate for

the difference between the iCool temperature and the pool temperature

when selecting your required temperature. For example: if the pool is

2° warmer than the iCool display then set the iCool 2° lower to achieve

your exact pool temperature. All iCools maintain the water in their heat

exchanger tanks to within less than half a degree of your setting.

Heat Pump

The heat pump temperature window shows the temperature inside the

cabinet. If this exceeds 70°C or 158°F the system will shut down, an

alarm will sound and a warning screen will appear. This could happen in

extremely hot conditions or if the unit is covered by an object such as a

towel or anything that prevents proper airflow.

The outside temperature window shows the current room or outside
temperature. It is not desirable to operate this system in temperatures

above 42°C or 108° F. If the reading exceeds this you need to move the

system to a cooler area or improve the air flow. The preset temperature
window always shows your selected temperature. This is the
temperature the water will be automatically cooled (or heated) to and
maintained at within half of one degree C.

Changing the temperature setting

You can change your preset temperature at any time by touching the
change setting button, this will take you to the change settings screen.
From here you proceed as described previously.

Note: If you have the contrast model, for safety reasons you cannot
change directly from heating to cooling or cooling to heating. To do
this you must switch off the entire system at the main switch and start
again. This is required to reset the computer for safe monitoring.

Fan Speeds

During normal operation the main fan will automatically change speeds

as required to maintain the highest efficiency. The fan will be at full

speed when temperatures are high or the water is warm.

You can display the pool temperature at full-screen size

If you touch the number in the pool temperature window on the Main

Operation Screen for a few seconds the screen will change to a full-

screen display of that temperature as shown in the picture at right.
This is useful if you wish to monitor the system from a distance. The

pre-set temperature and the outside temperature continued to display

in smaller windows for your reference To return to the main operating

screen touch the BACK 1 button.

To stop the system at the end of your recovery session

There are several ways to stop the system and close it down. You can
stop the cooling system by touching the stop system button, in this
case the pump will continue to run, however you can stop to pump at
any time by touching the stop pump button. Alternatively you can stop
everything by touching the all stop button. Alternatively you can simply
switch off the main power. If you use the all stop button the fan may
continue to run for a short time to cool the cabinet.

Emptying the pool using the built in Pump

You can use the main circulating pump to empty the water from the pool
by detaching the top hose from the top of the pool and directing it to a
drain. The pump can be turned on and off at any time using the pumps
stop/start button.

DETAILED OPERATION

DETAILS OF THE MAIN OPERATING SCREEN

Pool Temperature Screen

Water Temperature Full Screen