iConnectivity mio10, Owner'S Manual

Page: 11 / 21

7
iConfig Software
The included iConfig program looks and works the same on Mac and Windows. Use it to
configure all the setup, MIDI routing, and MIDI processing features in your mio10. iConfig also
works with additional iConnectivity interfaces connected to the same computer; you only need
one installation.
IMPORTANT NOTE: To save the mio10’s configuration to memory, select “Device” on the top
menu bar, and then select “Save Current Settings”. The settings will be stored in non-volatile
memory while the mio is powered off.
The following sections explain each page that appears under the tabs at the top of the iConfig
application.
Device Info Page
This page displays overall information about the mio10, and is used to configure its Ethernet
settings.
Device Information:
The Device Name field is editable, so you can give the mio10 a unique name.
Ethernet Information:
IP Mode (Dynamic IP, Static IP). Every device on a network has a unique IP address number to
identify it. When set to Dynamic IP (the default) the IP address is assigned to the mio10 each
time it connects to the computer. When set to Static IP the mio10 IP address is entered
manually. If other devices on the same network as the mio10 need a consistent IP address
every time they start up, you can avoid conflicts by assigning mio10 a fixed IP Address, Subnet
Mask, and Gateway here.